How to use the blow molding machine?

Update: 2021/08/04
Abstract:

The use of mineral water bottle blowing machine pay att […]

The use of mineral water bottle blowing machine pay attention to the use of mineral water bottle blowing machine is mainly used to blow mineral water bottles of machinery and equipment, it can blow plastic particles or preforms into bottles through certain technological means, for people in life It is convenient to use plastic bottles of various shapes. The blow molding machine mainly uses oil-free airbag mold clamping technology to operate. Not only the clamping force is large, but the toggle operation is less forced and has a long life. How to operate the bottle blowing machine to make it easier and more convenient to use, and to extend the service life of the bottle blowing machine?

1. When people use the blow molding machine, they should carefully check whether the power supply, control system, heating system, etc. of the blow molding machine are in a normal state, and for the parts that need to be added with lubricating oil, they need to add an appropriate amount of lubricating oil to ensure To ensure the normal use and operation of the equipment.
2. When using the blow molding machine, the mold should be accurately installed on the blow molding machine, and check whether the button is in the correct position, and also need to start, debug or run in accordance with the specified requirements, and make sure The machinery and equipment are running and working under normal conditions.
Specific operation steps of automatic bottle blowing machine:
1. When operating the bottle blowing machine, you should first place the preform in the preform container, and then use the conveying device in the machine to automatically enter the automatic positioning device according to the preform, and then move the preform mouth upwards , Loaded onto the preform holder and sent to the drying tunnel.
2. After heating, the preform will be sent to the blowing and stretching platform for mold clamping. After the low pressure and high pressure blowing and stretching, the gas will be removed, and finally the mold will be opened. Take off the formed bottle.

0

0
Views: 346
Contact Us