What are the operating points of the blow molding machine?

Operation points of the blow molding machine:
1. Before starting the blow molding machine, it is necessary to add lubricating oil to each moving part once.
2. The swing arm can be added once (3-4) days, and the large chain and small chain of the heating machine can be added once a month. It is necessary to frequently check whether the main reducer and the heater reducer are short of oil. The main engine bearing can be added once every 3 months.
3. Before production, check whether the moving parts are firm, whether the screws are loose and falling off, especially whether the transmission parts are abnormal in places with strong impact force.

4. Check whether the high-pressure air source, low-pressure air source, power supply, and water source are normal.
5. Check whether the emergency stop switch, safety door switch, and protection device detection switch are normal.
6. Check whether the heating head enters the embryo and the embryo drop part is working normally.
7. Check whether the lamp tube is damaged or cracked. To be replaced in time.
8. Check whether each pneumatic component is leaking and whether the action is sensitive.
9. Check whether the triple valve body is abnormally leaking, whether it is blocked, and whether the water storage capacity of the water cup is too full.
10. When the solenoid valve of the blow molding machine is abnormal, it should be cleaned in time.
11. The blowing mold must be cleaned and cleaned regularly.